How To Set The Floating Bridge on a Archtop Guitar - YouTube The other is to “deck” the tremolo by adding extra springs and tightening the spring claw to deck the bridge against the body. The Bigsby became the first commercially successful vibrato system until the Fender Stratocaster standardised the design in the mid-fifties. It provides players with a way of achieving vibrato (minor pitch waves) without bending the strings through your fingers. After the bridge is floating properly, you will probably notice that the string action has raised slightly. These bridges are most often found on hollow or semihollow electric guitars, where drilling into the top to mount a fixed bridge could weaken the structure of the guitar or impede its acoustic … Updated on Jun 22, 2017 at 4:34 PM. To adjust floating bridge intonation on a guitar, first check the 12th-fret harmonic and the fretted 12th-fret tuning of both E strings (high and low). Tuning and balancing a floating bridge is where many get frustrated and give up as it often leads to a lot of guesswork in finding the right balance, which could take quite a bit of time. One involves “blocking” the bridge by wedging a wood block between the trem system and the body of the guitar. Floating bridges were first introduced on archtop guitars way back in the 1920s. String up your guitar. By Dave Hunter. It’s important that you’re sure about your string size. Technically, the floating bridge is a type of fixed bridge. The back edge of the bridge comes up, and the strings pull the bridge off of the body. It gets its name from the fact that it isn’t actually attached to the top of the guitar but is held in place by the strings’ pressure on the saddles. Setting up your archtop guitar with a floating bridge is generally the same as setting up a normal guitar. There are two main methods to convert a Stratocaster with a floating tremolo bridge to a hardtail Stratocaster. To find out the general area where the bridge should be placed, measure the length of your neck from the nut to the 12th fret. At … Either tighten or release the spring claw until the entire base plate is floating off of the body parallel to the top. If properly intonated, the fretted and harmonic 12-fret pitches of both E strings will agree, with none of them being sharp or flat. Tune the guitar. The only thing that is different is that the bridge is completely removable and is held in position by the tension of your strings. If you change gauge later … On a blade-style bridge base plate, you will go through the process of re-tuning. By blocking off the bridge plate, you stabilize the bridge and prevent it from shifting as you tune your guitar.